What Kind Of Drywall Do You Use For Garage Walls?

What size of drywall is used in garages?

Also, ⅝” is the standard thickness for fire-resistant or fire-code drywall, commonly found in garages.

¼” drywall is relatively uncommon, and can be used for repairs or for curved areas, where you can double up two sheets to make a standard ½” sheet.

As far as lengths, the standard sheet size is 4′ x 8′..

What can I use for garage walls?

What is the best material for garage walls?Plywood and OSB.Fiberboard. Fibreboard is a practical material made of wood chips, which has various densities, and the most suitable type for garage walls is a hardboard, which typically has a 1/4 inch thick sheet. … Pegboard. … Metal Panels. … Vinyl Option.Apr 22, 2019

What should I put on the inside of my garage walls?

Drywall is only one option for garage walls, some of the other options include:Painting.Wood Paneling.Plywood Or OSB.Metal Panels.Plastic Or Fiberglass.Storage Panels, Such As Pegboards Or Slat Board.Moisture Resistant Backerboard.

Does garage drywall need to be taped?

Garage drywall, like any other area with drywall, should have tape embedded over all the joints. I like to use the pre-creased paper tape. It’s not sticky like typical tape, but with an initial layer of mud, you can use it on all of the straight joints, and also on the inside corners.

Should you mold resistant drywall in garage?

Don’t worry about using a mold and moisture resistant board, not worth the money. If the outer garage walls and ceiling are not insulated then spend your money there and insulate them. You could also run some heat out to the garage if that is practical for you.

How far into stud should screw go?

1/4 inchPush the tip of a drywall screw into the drywall at a stud location. At the edge of the panels, the screw should be no less than 1/4 inch from the edge. Any less than this and you run the risk of crushing the edge of the drywall. The sharp tip should stick firmly into drywall, enough to hold it in place.

What is the best material for garage walls?

Plywood or OSB board: Wood walls make a durable option for garages: They can take a beating from teenagers carelessly backing out the family car and are strong enough to hang tools and equipment without worrying so much about studs. They also help absorb sound.

Can Drywall be used in unheated garage?

Short answer is yes, you can drywall an unheated garage. The problem won’t come from the heat but the humidity, which causes moisture, which causes rot and mold. Even though unheated, ventilation and a dehumidifier may be necessary depending on where you live.

What is the best color to paint the inside of a garage?

Garage Wall Paint Ideas Neutral colors like gray, beige or tan will be easier to clean and maintain than a white shade. Also consider using a semigloss paint because it will make dirt less evident and is easy to wipe clean.

Can you drywall a garage without insulation?

Yeah do not drywall if you aren’t insulating. I don’t see a point at all. If you want it warmer, at least insulate and vapor barrier. You may not need a heat source with a garage of that size and a warm truck/attached house.

How thick should Plywood be for garage walls?

The International Residential Code specifies 3/8-inch plywood for sheathing walls with a standard stud spacing of 16 inches, if the siding is nailed to the studs through the sheathing. If the nails penetrate the sheathing, but not the studs, the minimum plywood thickness that the IRC designates is 1/2 inch.

Should I use drywall or plywood in my garage?

Even if your area is not bound by the residential code, most homeowners prefer to use drywall over plywood. This provides added protection and safety in the possible incident of a fire hazard.

Do I need moisture-resistant drywall in garage?

Standard drywall panels contain compressed particles of gypsum covered with thick paper. That’s fine in your home, but unless you’re finishing your garage as a living space, complete with insulation and a heat and air system, moisture-resistant drywall is preferable.

Can you use 1/2 inch drywall ceiling?

1/2-inch: Half-inch drywall panels are the standard thickness for interior walls, as well as ceilings. 5/8-inch: These panels are commonly used for ceilings, or for walls that require a prescribed fire-resistant rating.

Is shiplap cheaper than drywall?

Shiplap cost ranges between $2.50 and $7.00 per square foot for real boards. … A 4 x 8-inch sheet of drywall might cost you less than a shiplap board, but it can actually turn out to be quite expensive overall after the finishing process.

What can I use instead of drywall in garage?

Instead of drywall, consider covering garage walls with cement board panels. These panels make it easy to add tile, or even stone veneer. Using stone veneer over cement board, you can create an exposed brick or natural stone wall in the garage.

What is code for drywall in a garage?

The IRC code requires 1/2″ rock on the garage side of the garage walls and any supporting structure (steel posts, stud walls, etc). If there is habitable space above the garage then 5/8″ is required on the ceiling and any horizontal members such as steel beams.

Should I put drywall in my garage?

Drywalling Your Garage Is a Great Project For those that spend a lot of time in the garage or have some of their most valuable belongings in there, putting up drywall in your garage is definitely worth while. It adds protection, appeal and longevity to your garage as a whole.

Is moisture resistant drywall required by code?

The surfaces of tub and shower surrounds are required to water resistant. … Technically, the building code does allow water resistant sheetrock installed on ceilings of tubs and showers, but it must be nailed to ceiling joists that are spaced no more than 12″ apart.

Is it better to hang drywall vertical or horizontal?

On commercial jobs, fire codes often require seams to fall on the entire length of the framing, so the drywall must be hung vertically. … For walls 9 feet high or shorter, hanging the drywall horizontally has a number of benefits. Fewer seams. Horizontal hanging reduces the lineal footage of seams by about 25%.

Can I use plywood instead of drywall in my garage?

In areas that have adopted the IBC, you will need to have one layer of 5/8″ Type X drywall mudded and taped between the garage and any living space. You can hang plywood or peg board over that, no problem.