Why Is My Genie Garage Door Not Opening?

What do you do if your garage door won’t open?

Make sure the opener is plugged in.Check the circuit breaker that powers the opener.Did someone lock the door?Check to see if the trolley has been disconnected.If you suspect the problem is in the remote, try resetting it.Clean the photo eye.Adjust the opener’s pulling force.The door might be off the track.More items….

Is there a reset button on my Genie garage door opener?

Push and hold the square “Program Set” button for at least 3 seconds. Keep holding the button until the circular LED is lit up. The oblong LED adjacent to the circular LED will then flash purple. This puts your opener into Programming Mode, which allows you to reset the device.

Do Genie garage door openers have a fuse?

The Genie 34138A10F 10-amp replacement fuse from Garage Door Supply Company is for use with Genie Excelerator residential garage door openers. It’s a plug-in fuse that plugs into Genie Excelerator garage door operator drive boards.

Why does my Genie garage door opener reverse open when I try closing it?

Why does my Genie garage door opener reverse/open when I try closing it? The likely culprit is an obstruction in the path of the garage door. Check for and clear any obstructions in its way. If the problem persists, check to see if the red Safe-T-Beam LED indicator is blinking.

What would cause a garage door not to open?

A broken spring repair is one of the most common reasons why a garage door is not opening. Garage tension springs store mechanical energy that controls the movement of the garage door. Wear and tear could weaken the tension springs, which could lead to the garage door not working.

Why will my garage door close but not open?

If your door won’t open or opens then immediately closes, here are some tips for you: Sensitivity of the opener needs adjustment. Remote batteries need replacing. Garage Door springs need replacing.

Why is my Genie garage door opener not working?

The problem is either due to a blocked path between the sensors, dirty eyes, loose wires at the sensors or at the motor head, or just bad sensors. The transmitters (remotes) will not work to close the garage door. … Also, try unplugging the garage door opener and re-plugging the unit back into the outlet.

How do I fix my Genie garage door opener?

Opener does NOT operate when the wall console is pressedTurn Sure-Lock OFF (also called vacation lock)Check the power source where the powerhead is plugged in.Plug a lamp into the same outlet, if the lamp works the power source is ok, if the lamp does not work, check the fuse or breaker.If the power is OK-More items…

How do I reset my Genie Excelerator garage door opener?

How to Reset the Genie Excelerator Remote AccessSet up a stepladder under the rear of the Excelerator motor. Locate the terminal block on the back of the motor assembly. … Press and hold the “Learn” button. … Tap the “Learn” button with your finger. … Press and release the button on the remote control. … Repeat this programming for each remote control.Sep 26, 2017

How do you reset a Genie garage door opener after a power outage?

Re-Engaging Your Garage Door Opener After a Power OutagePull the emergency-release rope toward the opener motor head. This prevents the carriage from reconnecting to the opener rail trolley, allowing full manual operation of the door.Raise the garage door fully. … Push the control button either on a remote or at the wall station to operate the garage door opener.

Why does my garage door opener only open and not close?

The problem is usually either due to a blocked path between the sensors, dirty safety eyes, loose wires at the sensors or at the motor head, bad sensors, or bad motor control board. Also, try unplugging the garage door opener and re-plugging the unit back into the outlet. …